Retracta Security Steel Posts - Telescopic

A simple, cost efficient security steel post, but highly effective and convenient way to prevent unwanted vehicle access and deter ram raids. The lock is positioned at the base of the post.

A choice of padlocks are available to offer an increasing level of security, padlocks are extra. The post is operated by lifting fully out of the ground and then rotating 45 deg. The lug at the rear of the post aligns with the flap to allow the padlock to lock the post to the flap.

SPECIFICATION

• No internal mechanism.
• Mild steel inner sleeve facilitates smooth moving action.
• Competitively priced.
• Standard or higher security padlocks can be fitted.
• In the event of damage, the sliding post can be replaced by authorised key holders.
• Will only lock in the up position – no jamming possible below ground.
• Flap design helps protect padlock from malicious attack.
• All parts are fully galvanised and corrosion protected.
• Painting and powder coating coloured finishes available extra.
• Supplied with self-adhesive safety reflector for higher visibility.

RETRACTAPOST

• Height Above Ground 745mm
• Below Ground 1005mm
• Wall thickness 3.2mm
• Gross Weight 28kgs
• Lifting weight 8kgs

RETRACTAPOST (Baby)

• Height Above Ground 500mm
• Below Ground 755mm
• Wall thickness 3.2mm
• Gross Weight 20kgs
• Lifting weight 6kgs

INSTALLATION

Full instructions are supplied with each post. Excavated hole 1100mm deep and 300mm diameter. Install with chippings in the bottom to allow drainage. Lid of post should be no more than 10mm above ground level. Concrete should be used to cover the top 360mm of the hole around the post. Keep sliding post clean and occasionally lubricate lock with Ambersil 40+.

Warranty Information