Retractapost - GL Security Steel Post

SUMMARY

The RetractaPost-GL range of posts are suitable for car show rooms, access control, car parks, retail parks, shop fronts and domestic driveways.

The posts have an integral push lock at the base of the post and are supplied with two keys with push to lock action. The posts are manufactured in house by Autopa and are available in two sizes and a variety of finishes.

To operate the post, fully extend out of the ground and then rotate 45deg. To lock push the lock at the base of the post.

SPECIFICATION

• Made from mild steel round tube.
• Galvanised finish is standard.
• Colour coated finishes available extra.
• Lockable in the up position.
• 7 pin anti drill centre push lock.
• Supplied with 2 keys.
• Available randomly or identically keyed.
• Includes sprung flap cover to protect the lock.
• All galvanised RetractaPosts are supplied with reflective tape.

RetractaPost-GL, 90mm

• Height above ground 745mm
• Below ground 1070mm
• Diameter 90mm
• Wall thickness 3.6mm
• Gross weight 30kgs
• Lifting weight 7kgs

RetractaPost-GL, 101mm

• Height above ground 745mm
• Below ground 1070mm
• Diameter 101mm
• Wall thickness 3.6mm
• Gross weight 36kgs
• Lifting weight 10kgs

RetractaPost-GL, 114mm

• Height above ground 900mm
• Below ground 1251mm
• Diameter 114mm
• Wall thickness 3.6mm
• Gross weight 48kgs
• Lifting weight 12kgs

INSTALLATION

Full instructions are supplied with each security steel postpost. Excavated hole 1100mm deep and 300mm diameter. Install with chippings in the bottom to allow drainage. Lid of post should be no more than 10mm above ground level. Concrete should be used to cover the top 360mm of the hole around the post. Keep sliding post clean and occasionally lubricate lock with Ambersil 40+.

Warranty Information

This product comes with a 1 year warranty as standard